ZK -SAMp Uživatelský manuál stáhnout pdf (Strana 30)

201 Circle Drive N, Suite 116 Piscataway, NJ 08854 Tel: 732-412-6007 Fax: 732-412-6008

www.zkaccess.com

In addition, the system does not allow the same Linkage Setting at an input point and an output point in a specific trigger

condition.

The same device permits consecutive logical (as mentioned above) Linkage Settings.

Video linkage includes hard linkage and soft linkage. The hard linkage is the same as the previous description. The system will

synchronize the setting information to access control panels. The access control panel (no matter if it is offline or online) can

execute the current linkage setting. The soft linkage is only applicable to the video linkage. After the system obtains a

particular real-time event from the access control panel, you can use the software to query the video data from the hard disk

and play on the interface.



Note: The video linkage function is only available for professional version 5.0.8 and above. If you need to use the video

linkage function, please contact our commercial representative or sales support.

6.4 Access Levels

Access Levels means in a specific time period, which door or door combination can be opened through verification. However,

the personnel combination that can open these doors via verification shall be set in Personnel Access Levels Settings. Please

refer to 6.5 Personnel Access Levels settings.

Add Access Levels:

1. Click [Access Control System] - [Access Levels] - [Add] to enter Add Access Levels edit interface;

2. Set parameters: Access Level Name (no repetition), Access Control Time Zones, Door Combination;

3. Click [OK] to complete the setting and quit. The added access levels will appear in the list.



Note:

(1) Select the doors in the Access Levels as multi-choice, so you can select different doors in different control panels;

(2) Two levels with the same time zone and door combination are not allowed in the system.

6.5 Personnel Access Levels

To assign access levels for personnel to verify and pass through, Personnel Access Levels have two display modes:

Show by Access Levels: Add/delete personnel for specific access levels.

Show by Personnel: Add specified personnel into specified access levels, or delete specified personnel from specified

access levels;

1. Add/Delete Personnel to Levels:

(1) Click [Access Control System] - [Personnel Access Levels] - [Shown by Access Levels], click a level, then personnel

having opening levels in the access level will be shown in the list on the right;

(2) Click [Add Personnel] to open the Add Personnel interface, select personnel to create the list on the right, and click [OK] to

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 51 52

Žádné komentáře

ZK -SAMp Uživatelský manuál Strana 30